
EG
EXHAUST HOSE KIT INSTALLATION
CARE AND CLEANING
WARNING! For safety’s sake, be sure to turn the air conditioner OFF and also
disconnect it from the power supply before cleaning it.
1. Cleaning of the Air Filters
The air filters must be checked at least once every two weeks operation.
Operation with a dirty filter always causes a lower efficiency of the air condi-
tioner and severe product dama
Flex. Tube/nozzle
connector
• Connect exhaust hose kit to the back of the unit and place the unit near the window.
Extend the flexible tube just enough to reach the outdoor, passing under the window
shutters set ajar.
• In case there is a window sill towards the inside of the room, it might be better to use the supplied
outlet nozzle. Insert the nozzle into the free end of the flexible tube
• Open the window and lock one of the shutters. Place the outlet nozzle between the two shutters
•
Avoid sharp bends or plies of the flexible tube.
Hot air outlet
connector
Flexible tube
Exhaust nozzle
EXHAUST HOSE KIT
e.The filter can be removed from the rear
side of the unit. Use a vacuum cleaner to remove light dust. If there is sticky
dust on the
ilter, wash it with lukewarm soap
water, then rinse in clean,
cold water and dry it before reinstallation.
2.
leanin
o
asin
and
rille
To clean the air conditioner, wipe it with a clean soft cloth, li
htl
moisted. In
case it is stained, moisten the cloth with soapy water. Never use solvents o
harsh chemicals, nor ver
hot water. Do not pour water over the air condi
t
oner to c
ean
t: t
s w
amage t
e
nterna
components an
cause an
l
tri
h
k h
z
r
.
3. Storag
I
ou are not
oin
to make use o
the air conditioner
or a lon
period
efore storing it away clean the air filter. Always store the unit in the vertical
position. Do not put heav
ob
ects on top o
the unit and protect it with a
cloth or a plastic bag.
. Transpor
Preferably keep the air conditioner in the vertical position during transporta-
tion. I
this is not possible, then la
it on one side; when at destination put
the air conditioner back in the vertical
osition and wait at least 4 hour
e
ore using it
or cooling
5. For
our sa
et
care check periodicall
the conditions o
the electri
supp
y ca
e;
n case you s
ou
not
ce any
amage
ue to usage, ca
the nearest A
ter
ale
ervice to
et the cable replaced.
Comentarios a estos manuales