Argoclima Hi Floor Classic Instrucciones de operaciones descargar pdf (Pagina 4)

V 05/10 4

HOW TO ASSEMBLE THE FEET SUPPLIED

The convector is packed without feet. These must therefore be assembled before using the appliance.

To fix the feet supplied to the convector base, insert each at one of the two sides of the base, and slide them to the limit

stop.

View from below of the side of the convector base

without the foot fitted.

Convector foot to be inserted laterally in the specific

space.

The foot must be allowed to slide along the specific

grooves, in the direction indicated by the arrows .

The foot is now correctly assembled.

HOW TO USE THE CONVECTOR

Choose a suitable place to position the convector, considering the general safety warnings given in the first part of this

manual. Only use this convector in an upright position.

Insert the plug into the electrical socket, ensuring that voltage is compliant with that specified on the convector data plate.

Select the desired temperature using the thermostat: L means low temperature and H means high temperature. The

convector will only start operating only if the thermostat is above minimum temperature (turn the thermostat in a

clockwise direction - from L to H).

Now choose the desired power level and turbo mode if required, using the power selector as shown in the image below.

1 - Low power (1000 Watts) 2 - High power (2000 Watts) u - High power (2000 Watts) +

forced ventilation (turbo)

By turning the thermostat dial, the temperature can be regulated as desired. Remember that once the temperature has

been set, the convector will operate until this temperature is reached and then maintain the temperature by turning itself

on and off as necessary.

To turn the convector off completely turn the power selector back to 0 and then rotate the thermostat dial anticlockwise

until it clicks off.

Unplug the appliance if it will not be used for a while.

1 2 3 4 5

Sin comentarios

Argoclima Hi Floor Classic Instrucciones de operaciones Pagina 4